8,009.4x :CAP_FAULT_MP_NO_ CLUTCH_STALL: The media path motor has stalled while moving without the clutch engaged. 33,001.4x - TM_DEV_FAULT_MPT_WIDTH_VALUE_TOO_LOW Tray 1 status: 1. Check the wiring and connectors from the front door to the I/O board. 2. Run the Test Tray 1 Width Sensors. 3. If the test fails replace the front door. 4. Replace the I/O board. 08.055.44 : The media path drive module has stalled while engaging the head tilt. 37,008.44 : The Preheat preheater is not drawing the expected power from the supply. Run the Preheat Heater test, check the wiring. If test fails and no apparently problem is evident, replace the preheater. 05,002.42 : Problems with the Y-axis. It could be the belt,motor or the drum. 7,008.4x : PM_FAULT_HEADTILT_NOT_ ENGAGED The printhead tilt is not engaged, so it didn't tilt back properly or the printhead is stuck in the tilted position by the tilt lock arms. The process motor gear train getting out of sync can
Reset printers and cartridge. Printers problem solving,tips, tricks and tutorial.